• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

240 Opening a Mini-Tach to change the gauge face

dandeluca

Member
Joined
Jun 17, 2020
Location
Bordentown NJ
I finally got my hands on a 52mm mini tach. I purchased a gauge face a while ago from Dave Barton to match the ones I replaced in the dash. My only question is how to open the mini tach up. I see no obvious way and I really don?t want to break anything. If anyone has done it before I?d appreciate the advice.
 
You will either destroy the bezel trying to pry it off or you'll need to cut the plastic behind the face to separate the front. Then just wrap the two sections with tape. You won't notice it once installed.
 
Back
Top