home register FAQ memberlist calendar

Go Back   Turbobricks Forums > Mechanical > performance & modifications

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 04-09-2021, 01:05 PM   #1
itlksez
Board Member
 
itlksez's Avatar
 
Join Date: Oct 2009
Location: Post Falls, ID
Default Ballast Resistor?

1987 740, B230f, LH-Jetronic 2.2

Quick question: I swapped this engine into an old Jeep. I had an issue with power to the coil during the swap, so I ran 12v directly to the coil (through a diode so I could shut it off) from the ignition switch. If Iím bypassing wherever the coil power came from before, do I need an external ballast resistor in this power source? Two different coils for the same application on rockauto; one says it needs external resistor, one says not required.

I just donít want to fry anything by not running one if the prior setup had one built in.

Thanks!
itlksez is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -4. The time now is 11:13 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.