• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Chop Chop Chop

noz-e8tr

noz-e8tr

Well-known member
Joined
Aug 27, 2003
Location
Ocean Springs, MS
Made this side by side after someone on FaceBook asked if I was going to lower the car. I think I removed 25lbs of metal to drop it this far. These are big tires and wheels. It might not look that low, but I've removed a lot of fender, cut the factory bump stops and have it as low as I can go with Bens rear coil overs. that's about as low as I can go with the one piece driveshaft unless I start massaging the floor.


Where I started...................................................................................Where I stopped.
BBF3777C-E307-44B7-BA73-B0C00C9D0667_zpsndrj2xdk.jpg
 
I was about to say "dude that's exactly the same distance from tire to flare"


I'm not a smart man.


Looks good though, I'd love to see some whole car pictures
 
slow240 said:
I was about to say "dude that's exactly the same distance from tire to flare"


I'm not a smart man.


Looks good though, I'd love to see some whole car pictures
Click to expand...

Thanks to your comment I managed not to embarrass myself as well.
 
You must log in or register to reply here.
Back
Top