92White240
New member
- Joined
- Mar 27, 2020
- Location
- pnw
Sorry if this has been answered, couldn't find a answer, but how does one measure and what is the stock ride height of a 240 sedan? I would like to measure before lowering. Thanks
-
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software hereThank you for being a part of our community!
240 Stock Ride Height Measurement?
- Thread starter 92White240
- Start date
doucheNozzle
Newbie
- Joined
- Feb 26, 2009
- Location
- The Pitt, 15147
It doesn't matter. Measure it however you want and do it the same way after you lower.
However, people usually measure either the gap between the bottom of the wheel opening and the top of the tire or the bottom of the wheel opening to the ground.
However, people usually measure either the gap between the bottom of the wheel opening and the top of the tire or the bottom of the wheel opening to the ground.
Redwood Chair
- Stock PSI Or Bust -
- Joined
- Mar 23, 2007
- Location
- Ocean Beach S.F.
Front and back of the rockers.
apachechef
Burnt Sierra Madre
- Joined
- Jan 26, 2009
- Location
- An obscure body in the SK system
in the days of old, the trolls would destroy these beauties just because wanted that lowered look.
now they want metrics to quantify their abuse.
Redwood Chair
- Stock PSI Or Bust -
- Joined
- Mar 23, 2007
- Location
- Ocean Beach S.F.
^^^ 
Nobody cares anyway other than IPD when they take your money.
Nobody cares anyway other than IPD when they take your money.
92White240
New member
- Joined
- Mar 27, 2020
- Location
- pnw
I'm looking for a factory height number to compare to mine for sag before I lower, not to see how much I lower it, but thanks
92White240
New member
- Joined
- Mar 27, 2020
- Location
- pnw
Looking for a number so I can measure sag lol, but yes I'm "abusing" it
doucheNozzle
Newbie
- Joined
- Feb 26, 2009
- Location
- The Pitt, 15147
So what number did you find for factory ride height?
Redwood Chair
- Stock PSI Or Bust -
- Joined
- Mar 23, 2007
- Location
- Ocean Beach S.F.
Last edited:
cleanflametrap
Well-known member
- Joined
- Sep 3, 2009
- Location
- near baltimore
Mine measure 19" from the ground, when up high enough to slip the bell housing out on top of a transmission jack.
92White240
New member
- Joined
- Mar 27, 2020
- Location
- pnw
I didn't.
I've gotten mount everest and 19' for a bell housing, but thats about it lol
Otto Mattik
board member
- Joined
- Dec 24, 2015
- Location
- Upper Midwest more or less
Mine measure 19" from the ground, when up high enough to slip the bell housing out on top of a transmission jack.
Tha camber tho
