home register FAQ memberlist calendar

Go Back   Turbobricks Forums > Mechanical > maintenance & nonperformance

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 01-07-2021, 06:05 PM   #1
Inside_the_box
Board Member
 
Join Date: Jan 2014
Location: Falls Church, Va
Default Distributor Connector Replacement

I've got an 87 240, the 3 pin connector on the side is broken. I ordered a new one and have removed the distributor. It looks like I need to remove the hall effect sensor to properly insert the connector. How do I remove this? Do I have to drive out the pin holding on the gear on the bottom and pull the shaft up through the top?
Inside_the_box is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -4. The time now is 02:13 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.