home register FAQ memberlist calendar

Go Back   Turbobricks Forums > Mechanical > maintenance & nonperformance

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 09-10-2022, 11:29 AM   #1
spock345
Board Member
 
spock345's Avatar
 
Join Date: Nov 2016
Location: Livermore, CA
Default U joint pain and misery.

I am right now working on replacing the u joints on my amazon. I found the rearmost joint was rather crunchy (no grease fitting) and I've already done the front most joint. So I decided it was time to do the two in the rear half of the shaft.

I ran into some trouble. I bought some moog 341 joints, which should fit but I wasn't able to get the clip into the grooves on both sides. I decided to compare them to the GMB joint I had lying around (came missing grease nipple and clips, so it sat in the parts bin). It would appear that the moog joints are a bit too long along both axes to fit quite right. A bit less than a millimeter. How should I proceed? Go find another u joint and grab a grease nipple for the GMB? Be very careful with some sandpaper on the caps of the moog joints? Give up and day drink?

I'd like to get the car out of the garage so I can do the brakes on my VW.
__________________
1967 122s, carbed B20F, M41, the sports tractor
1998 S70, grandma-mobile
1980 245
1989 240 B230F, V15 cam, chipped EZK, M47 swap (Lost a fight with a Chevy express van), the millennial falcon
2012 VW Tiguan (screw plastic water pumps), daily
spock345 is offline   Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Forum Jump


All times are GMT -4. The time now is 01:16 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2022, vBulletin Solutions Inc.