supreme940
Member
- Joined
- Nov 15, 2014
- Location
- MA
I'm currently running a ford EDIS coil pack with a j702t ignition module. I have a yoshifab coil bracket and a set of D514A coils but I'm not sure how to go about wiring them in.
They have a four pin connector and seem to be triggered by a +5v source.
Do I have to run a 5v line to each coil? Or can i get away with just the switched 12v, ground, and ground trigger from the ignition module?
They have a four pin connector and seem to be triggered by a +5v source.
Do I have to run a 5v line to each coil? Or can i get away with just the switched 12v, ground, and ground trigger from the ignition module?
Last edited: