• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

D514 Coil Wiring

S

supreme940

Member
Joined
Nov 15, 2014
Location
MA
I'm currently running a ford EDIS coil pack with a j702t ignition module. I have a yoshifab coil bracket and a set of D514A coils but I'm not sure how to go about wiring them in.

They have a four pin connector and seem to be triggered by a +5v source.

131466d1421734334-lsx-coil-thread-ls1_coil_schematic.gif


Do I have to run a 5v line to each coil? Or can i get away with just the switched 12v, ground, and ground trigger from the ignition module?
 
Last edited:
You must log in or register to reply here.
Back
Top