HiSPL
Fanking Champion 1993
- Joined
- Jan 8, 2015
- Location
- College Station, TX
So I'm going to do all sphericals on the axle end and stock rubber on the chassis end of my 240. My thought was to just chop the axle end of the stock torque rod and weld in a heim joint or a johnny johnny joint, but does anyone know what the ID of that stock tube is? I daily drive this car so removing a rod and cutting it open to measure is problematic! lol...
Also what do you think about the Heim vs Johnny Joint?
Also what do you think about the Heim vs Johnny Joint?