• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

240 ball joint stud taper angle and diameter?

Jerd

Active member
Joined
Mar 1, 2008
Location
Vancouver WA
1992 240 ABS.

I'm hoping to learn what the factory ball joint stud receiver dimensions are. I'm certainly going to run into a hard bind with the amount of droop travel I'm planning to run, and I would like to make my own ball joint extension and mount. Lots of cool aftermarket universal style ball joints out there, hoping to narrow down the selection by learning the OE stud type.

Thanks!
 
Last edited:
Back
Top