M.H. Yount
Active member
- Joined
- Nov 1, 2008
- Location
- Charlotte, NC
What went wrong? I'll bet you have a new appreciation for why steel bellhousings are a good idea for anything that's going to be 'used and abused'....
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
What went wrong? I'll bet you have a new appreciation for why steel bellhousings are a good idea for anything that's going to be 'used and abused'....
Scattershield is a very good idea .
Holy F Jared. Hope you get that figured out
Nothing let loose-just too much pressure plate
What did you do for the shifter hole on your swap? Mine was an auto, so i'm not sure what is normally there in a manual car. Also, does your tranny lean to the left in the shifter hole?
the shifter box will unbolt and leave a hole.
the shifter box will unbolt and leave a hole.