M47 bellhousing bolt pattern

Hello!

Does anyone have a drawing or notes of the bolt pattern between the bellhousing and the transmission of an M45/6/7 gearbox? It?s four bolt holes and their location in relation to the center hole for the shaft I?m after. I?m looking to make an adapter plate to adapt a Volvo bellhousing to a non-Volvo transmission.

Thanks,
Dennis

OK so I got one and measured it myself. In case anyone finds this thread in 2027, here are the dimensions:

A rectangular and symmetrical pattern of 12mm holes around a 32mm centerbore.
140mm cc width.
150mm cc height.

Bolt pattern is offset 10mm downward in relation to the centerbore. This makes the cc measurement between the centerbore and the bolt holes 65mm up and 85mm down.

Wonder if the M46 would be the same?

Yes, M45/6/7 are the same.