• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

t-56 behind a redblock

Status
Not open for further replies.
Looks like this is a good tranny. 450lb capacity, good gears with a 3.90 or 4.11. Its aftermarket gm, made to fit older picups, so it could have the standard 4 bolt pattern. I need to do more research.

1386-000-011 GM Aftermarket Any 6 450 No 122 Mechanical 26 27 2.97 2.07 1.43 1.00 0.80 0.62 3.28
 
Looks like that part number is for a standard 4 bolt bellhousing.....so using one of Johns modified adapter, this T56 would be mint..

" http://www.sallee-chevrolet.com/BorgWarner/bwt56.cfm

It was designed as a direct replacement for the 3rdgen F-body T5 5-speed. The gearset was rated at 400lb-ft because of the smaller input shaft/countershaft interface and the wide-ratio gearing."
 
Poik is doing this trans swap. He welded an adapter to a modified redblock bellhousing. I'm sure he'll chime in with info at some point.
 
haltechsupra said:
T56 with t5 bellhousing, sts flywheel, Nascar triple disk converted to street twin, bent shifter, turbobricks gm trans adapter. More details here.

Click to expand...

Lol imagine searching up a decade-old thread to post a link to your ****ty YouTube channel to try and get some attention and views.
 
Last edited by a moderator:
Status
Not open for further replies.
Back
Top