• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

Megasquirt ignition help

F

fastcomet

Member
Joined
Oct 5, 2016
I?m deep into installing new addition of Microsquirt. I?m kinda stumped and when I search I only get bits and pieces. Here?s what I have for setup.
60/2 flywheel (which is hooked up to shielded ms. Wires, I know this is correct)
124 ignition module
Coil Stock
Distributor that has no wires.

Looking for a diagram of some sort that applies.
 
i have micrsquirt on my b230 with lh2.4 its really good. but everything is in that manual, its properly good for learning,
 
hmm maybe I have downloaded and read a different manual than you guys have? I get bits and pieces but nothing like a complete diagram. I have the cps wired up as manual shows but doesnt show the rest of the ignition wiring. Not unless I just wire it up as it shows and ignore the dist. wiring? Anyways sorry for bugging you guys but man I have been searching. Maybe it will all come to me after some sleep. Thanks
 
fastcomet said:
hmm maybe I have downloaded and read a different manual than you guys have? I get bits and pieces but nothing like a complete diagram. I have the cps wired up as manual shows but doesnt show the rest of the ignition wiring. Not unless I just wire it up as it shows and ignore the dist. wiring? Anyways sorry for bugging you guys but man I have been searching. Maybe it will all come to me after some sleep. Thanks
Click to expand...

https://www.msextra.com/manuals/

http://www.megamanual.com/ms2/Bosch_124.htm


that first link will help you find nearly everything you need to figure out your harness -- the second is a bosch 124 specific page that should clear up at least some of your confusion.

Is there anything you have specific questions with?
 
Last edited:
You must log in or register to reply here.
Back
Top