SteveMD
Membro
- Joined
- Feb 15, 2004
- Location
- Well, I switched baristas.
dang i wish i was ready...
Well, I pm'd John V a week or 2 ago and no word back.
Hello Guest, welcome to the initial stages of our new platform!
You can find some additional information about where we are in the process of migrating the board and setting up our new software here
Thank you for being a part of our community!
dang i wish i was ready...
Well, I pm'd John V a week or 2 ago and no word back.
what about the squirters themselves? where can i get them?
Hey john, whats the center 2 center distance on the bushing fixture?
Who has the kit?
I haz it. I need to rent a 3/4 inch drill as the spot face cutter shank is too large for my 1/2 inch drill chucks. I hope to do that tomorrow at the earliest or Friday at the latest.
I haz it. I need to rent a 3/4 inch drill as the spot face cutter shank is too large for my 1/2 inch drill chucks. I hope to do that tomorrow at the earliest or Friday at the latest.
Damn, I'll see about turning the shank down a bit if it ever comes back to Sleezattle.
Whoops! False alarm. It turns out both my drills are 3/8 chuck. I'm hoping to borrow a 1/2 incher from a TB member Saturday.